EV Charging Services in Westminster, CA
Eight services covering every EV charging situation we encounter in Westminster garages, workplaces, and HOA lots — from a single outlet to a full 200-amp service upgrade.
Licensed California C-10 · EVITP-certified installers · Permit and inspection handled · Flat-rate pricing
Where To Start
Start With Your Panel, Not Your Charger
Almost every charging question ends up being an electrical question. How much capacity is left in your service, how far the panel sits from where the car parks, and whether the charger lives inside or out will decide the scope more than the brand you picked. Each service below is a page of its own with the detail specific to that job. If you are not sure which applies, call and describe the garage — that conversation usually takes two minutes.
Level 2 EV Charger Installation
Installing 240-volt Level 2 chargers that add roughly 20-40 miles of range per hour, the standard home-charging solution.
Read moreTesla Wall Connector Installation
Mounting and wiring the Tesla Wall Connector, including Gen 3 units, with correct breaker sizing and Wi-Fi commissioning.
Read moreNEMA 14-50 Outlet Installation
Installing a dedicated 240V NEMA 14-50 outlet in a garage or carport for plug-in mobile connectors.
Read moreElectrical Panel Upgrades for EV Charging
Upgrading 100A service to 200A, adding capacity, and clearing insufficient-panel conditions so a charger circuit can be added safely.
Read moreHardwired EV Charger Installation
Permanently hardwiring a charger to the panel for higher continuous amperage, outdoor durability, and code compliance on 60A circuits.
Read moreCommercial & Workplace EV Charging Stations
Installing single or multiple charging stations for offices, fleets, retail, and hospitality, including networked and payment-enabled units.
Read moreMulti-Family & HOA EV Charging
Charging solutions for apartments, condos, and HOA-governed communities, including load-shared and metered installations.
Read moreEV Charger Repair & Troubleshooting
Diagnosing faults, replacing failed units, correcting improper prior installs, and resolving breaker-tripping or charging-fault issues.
Read moreThe Process
How a Westminster Install Actually Goes
- 01
Free assessment
Describe the car, the parking spot, and the panel location. Most jobs can be scoped over the phone; complicated panels get a site visit.
- 02
Load calculation and flat quote
We calculate available capacity and put a fixed price in writing, materials and permit included.
- 03
Permit filed
Filed under our C-10 license before the crew is scheduled.
- 04
Installation
Circuit run, charger mounted, unit commissioned and tested with your vehicle.
- 05
Inspection and sign-off
We meet the inspector and close the permit. You get the documentation for rebates and tax credits.
Not Sure Which Service You Need?
Describe your setup and we will point you to the right one, even if the answer is that you do not need us yet.
Free assessment · flat-rate quote · permit and inspection handled